USING THREE CAMERAS
When you receive the monitor the DIP switch on the rear will have one channel set
in the down position. This represents Channel 1, enabling you to use the system
with one camera supplied. Refer to page 3 of the instructions for location of the
DIP switch.The white part in the diagram represents the switch.
USING ONE CAMERA
If adding additional cameras to your system you will need to change the DIP
switch to reflect the number of cameras being used.
USING TWO CAMERAS
To use two cameras, two channels need to be selected on the DIP switch. The
first two channels switches should be in the down position.
SETTING THE DIP SWITCHES
Page 5
Camera
DIP switches
The switch is in
the ON position
when it is in the
down position
Monitor
DIP switches
Channels 1&2
Selected
Camera 1
Camera 2
Monitor
Camera
DIP switches
Monitor
DIP switches
Monitor
DIP switches
All Channels
(1,2,3)
Selected
Camera 2
Camera 3
Monitor
Camera 1
Camera
DIP switches
The 2.4GHz video signals pass easily through your homes interior walls, but the
signal maybe reflected by power wires or plumbing inside the wall. Usually a
slight adjustment of the Monitor/ Receiver and / or Camera / Transmitter antenna
will improve reception. Take care not to force the antennas past their lock
positions.
Sound level can be adjusted using the volume control knob on the side of the
Monitor/ Receiver. Adjust the Brightness/Contrast as required using controls on
the rear of the Monitor/Receiver. If needed the vertical hold can also be adjusted
at the rear.
The most common source of interference are microwave ovens. Try to avoid
mounting the Monitor / Receiver near a microwave oven or other source of RF
interference such as cordless phones.
SWITCHING THE CAMERA ON / OFF
To preserve battery power the camera can be switched off while not in use.
Simply turn the antenna to the position shown below. Please note this will not turn
off the camera if powered by an AC power adaptor. With the antenna in any other
position than the one shown below, the camera will be turned on.
Camera Antenna in
Off position
Page 6
USING THE CMS244 VIDEO SYSTEM
Power LED
Antenna
