4. To get the best performance from the camera, please follow these guidelines.

For the best performance, mount the camera between 2.5 and 4 metres

above the detection area.

To avoid problems with false detection ensure no plants or obstructions which

could trigger the PIR are within the detection range.

The Camera has a 78º viewing angle, ensure the camera is set at the

optimum angle to cover the desired area.

For best transmission range try to ensure that there are no thick walls or

major obstructions.

If night time operation is required a good light source is required to illuminate

the area.

1. Unpack the camera / transmitter

2. Decide on wall or desk mounting the camera. If wall mounting there is a useful

drilling guide on the back cover of the instructions. The camera can be adjusted

for both by rotating the camera head to the required position.

INSTALLATION

3. Decide wether to connect using the camera power supply or batteries (not

included). If using batteries remove the battery compartment lid on rear of

camera and install 5 x AA batteries. If using the power supply, remove lid and

connect power jack. Snap the lid closed, trapping the cable in the slot behind

the tab. Make sure the camera is positioned no more than 2.5 metres from the

mains socket.

Desk/ Tabletop

Wall Mount

Page 1

Page 2

5. Select the transmission channel on the DIP switch in the battery compartment

by switching any one of the three switches. The camera is preset to Channel 1,

with the switch in the down position.

The monitor is factory set to receive the pictures from one camera, indicated by

switch no. 1 in the down position. Set the monitor and camera DIP switches as

shown below.

USING TWO CAMERAS

Camera 1

Camera 2

Cameras 1&2

Selected

Camera

DIP switches

Monitor

DIP switches

Monitor

DIP switches

Camera 2

Camera 3

All Cameras

(1,2,3)

Selected

Camera 1

Camera

DIP switches

The switch is ON

when it is in the

down position

USING THREE CAMERAS